Your water heater is one of the used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating as well as costs.
Regular flushing of your water heater is considered the single most important step you can take to prolong its service life and to save energy. During time, sediments strengthen in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is critical in today’s weather. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, on the internet should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located in the water inlet line going into your water heater. You can then connect a hose to the drain valve located at the bottom of the space heater. Open the drain and allow it to run until all of your water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out gradually. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and products to provide what you need.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610